E-Guitar (Work in Progress)

Skills Utilized:

  • Soldering
  • Woodworking
  • 3D Printing
  • Engineering Sketches

In winter 2023, I started building a custom electric guitar from scratch using particle board. This project is ongoing, and updates will be shared as progress continues:

Process So Far:

  • Shaping the Body:
    Using a jigsaw, I cut the guitar body out of particle board. The body comprises two laminated boards bonded with wood glue. Small holes were drilled in specific areas to allow wiring to pass through. I sanded the edges with fine-grit sandpaper to ensure a smooth finish and avoid splinters.


Fig 1. Guitar sketch on particle board


Fig 2. The two wood boards are laminated using wood glue


Fig 3. Cavity for controller and wirings on the back of the guitar

  • Installing Pickups:
    Humbucker pickups were mounted on the guitar body. These pickups reduce electrical noise and interference and ensure clean signal transmission from the strings.


Next Steps:

  1. Install the output jack onto the guitar body.
  2. Design and 3D print a cover for the cavity housing the controller.
  3. Mount the controller in the cavity and solder it to the output jack and humbucker pickups.
  4. Paint the guitar body with a red and white colour scheme.
  5. Attach the guitar strings and bridge plate.
  6. Conduct testing and make refinements as needed.



Comments

Post a Comment

Popular posts from this blog

Electric Bike

Image
  Skills Used: Soldering Iron Rotary Kit Heat Shrinks Prototyping and Testing Product Design Working with bike motors and bike controllers In the summer of 2022, I collaborated with a friend to design and construct an electric bicycle. The design required extensive soldering of wires and a rotary kit to trim the edges of the bike motor. For our project, we installed a throttle and a pedal assist system on the bike, allowing the power to be accessed in two different ways.  Below are some images of the design process and final product of the e-bike. We swapped out the bike's front wheel for a new one equipped with a pre-installed motor. Next, we used helping hands to solder the controller to the motor, pedal assist, and the display meter. To ensure insulation and added durability, we covered the wires with heat-shrink tubing.  The e-bike runs on a lithium battery, as seen above. The battery was housed in a pannier on the bike rack, and any loose wires were secured to the bi...
Read more

Arduino Claw System

Image
Skills Used: "C" Programming  Arduino Breadboard Engineering sketches Prototyping Risk Assessment During our first-year course at the University of British Columbia, we were tasked with designing an Arduino-controlled claw system using simple, everyday objects, such as cardboard, pencils, etc. Below are the components and final design of my claw retrieval system.
Read more

Aquaponics System

Image
Skills Used pH testing and control Research  Piping Pumping control In grade 12, I, alongside a peer, oversaw an aquaponic system located in our school's courtyard. Our objective was to grow microgreens by creating a recyclable system where both the fish and plants support each other. In our system, the fish excrement is converted into nitrate for the plants to grow, while the microgreens consume toxic ammonia within the fish tank so that the fish can survive. Below are some pictures of our system and final   product .
Read more